Advertisement
Step 3: Mount the long side of the axle shaft
Mount these parts in the following order on
the long side of the axle shaft. Observe the
direction of the insertion knives.
ANT:
Make sure that the upper bracket of
the centre support faces the short end of
the axle (A = long end)!
1. Start with a 0.79" spacer
2. Ø20 washer
3. Central support
4. Ø20 washer
5. 1.61" spacer
6. Double coil (knives point inwards)
7. Single coil
8. 2.76" spacer
9. Ø20 washer
Step 4: Fasten the end plates and the wheel holder
Start by turning the wheel holder in the
middle of the axle shaft so that it points up-
wards (A). Next, attach a side plate to one
side, followed by a Ø20 washer (5) and a
wheel holder. Note that the wheel carrier
ring is facing inwards. Fasten the wheel
bracket to the axle shaft with ¼"×1–
hexagonal bolt and ¼" locking nut. Tighten
the connection firmly. Repeat for the
other side.
1. Side plate
2. Wheel holder
3. Screws ¼"×1–
9
/
"
16
4. Locking nut ¼"
5. Flat washer
7
/
"
8
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
IMPORT-
9
/
"
16
Item 51707
Page 7
01
2021-1
Advertisement
