Advertisement
Step 11: Adjust handle and tighten connections
Place the lawn aerator right side up on the
wheels and lock the lifting handle into the off-
set at the front of the storage slot. Perform the
following steps to ensure correct alignment of
the lifting handle with the slot.
1. Adjust the compartment from side to side so
that the lifting handle rests on the right side
(seen from behind) of the offset on the front of
the slot.
2. Align the side plates and then tighten the
eight screws at the corners of the compart-
ment. Make sure that the lifting handle is still
on the right side of the slot offset.
3. Align the middle rail and tighten the two
screws that secure it to the tongue.
Make sure that the lifting handle is still on the
right side of the slot offset. You should bring
the handle into alignment with the slot when
lowering the lawn aerator. The locking device
is designed to help prevent the handle from
slipping out when the lawn aerator is in use.
But if you feel that this part does not fit cor-
rectly, simply remove the pin.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 51707
Page 11
01
2021-1
Advertisement
