Advertisement
Assembly instructions
Recommended tools for assembly
2 × combination wrench
1 × medium size adjustable spanner
1 × medium sized pliers
Before mounting the aerator, lay out all parts as shown on the previous pages.
ATTENTION:
BE CAREFUL WHEN INSTALLING AND USING THE LAWN AERATOR.
Step 1: Fasten the wheel holder to the axle shaft
1. Attach a wheel bracket to the middle
opening of the axle shaft. Note that the
wheel retainer ring should point to the
shortest side of the axle. Fasten the wheel
mount with a ¼"×1–
9
/
¼" hex lock nut (2). Do not tighten firmly.
2. Next, from the short side (A) of the axle,
insert a
5
/
"×1–
3
/
" (1) hexagonal bolt into
16
16
the hole on the wheel bracket closest to the
axle. (Smaller hole) Attach the
nut (3) to the bolt. Do not tighten screws.
Step 2: Mount the short side of the axle shaft.
Mount the lower parts on the short side of the axle shaft in
the following order. Observe the direction of the insertion
knives.
1. Start with a double coil (knife to the outside)
2. Single coil (knife to the outside)
3. 2.36" spacer (long)
4. Ø20 washer
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
7
/
" / ½" / ¾"
16
THE TIPS OF THE AERATOR BLADES ARE SHARP!
" hex bolt (4) and a
16
5
/
" hex lock
16
Item 51707
Page 6
01
2021-1
Advertisement
