Advertisement
3
To assemble the MIDDLE
& UPPER SECTIONS,
you will need two sets
of these pieces:
× 4
(connector rails )
4
To assemble the ROOF,
you will need this piece:
7501 — 07/15 — USL
The remaining panels all feature solid metal
guide tabs along the bottom wire and wire
clips on the side panels [see Fig. 3.1].
Start with the side panel. Use the guide tabs
to align it directly over the lower panel, then
clip the panels together by pressing down at the
middle (apex) of the wire clip [see Fig. 3.2].
Add the back panel—thick horizontal wires
to the exterior, aligning directly over the
lower panel with the guide tabs—and slide a
connector rail down over the two-panel seam.
Continue around the cage, adding the
side and front panels and attaching
panels with the connector rails.
Made in China for Prevue Pet Products, Inc., Chicago IL USA
Lay the roof panel over the top and weave
the loops over and under along the top edge.
Note: From the side, the center loop will
hook UNDER the horizontal wire. The loops
to the left and right will hook OVER the
top horizontal wire.
www.prevuepet.com
800 243-3624
[ FIG. 3.1 ]
CLICK
[ FIG. 3.2 ]
@
customerservice
prevuepet.com
Advertisement
