Preset Mode; Page 1 - Load Preset; Page 2 - Save/Copy Preset; Page 3 - Name Preset - Akai MPK 49 Operator's Manual

PRESET MODE

What is a Preset?
A Preset is a collection of information about how the MPK49's keyboard,
sliders, knobs, and pads will behave. Using Presets allows you to save
different configurations so you can quickly load them when you need them,
without having to reprogram the MPK49 every time.
The MPK49 features different Preset banks that you can load and write to. When you turn on the MPK49, it
will automatically go into Preset Mode and Preset 1 will be displayed on the screen. You can also press
the [PRESET] button at any time to call up this mode. In Preset Mode you can load, save/copy and
rename Presets – each of these functions can be accessed through the 3 different pages. You can
navigate between these pages with the [<] and [>] buttons.
PAGE 1 – LOAD PRESET
Preset Mode
1. While you are in
dial below the screen. Turning the dial increments or decrements the current
Preset number and displays the screen on the right:
When you do this, you will notice that 'PRESS ENTER' will begin to blink.
2. Pressing [ENTER] loads the selected Preset.
[PRESET] button cancels and returns you to the Preset that was last
selected.
PAGE 2 – SAVE/COPY PRESET
Preset Mode
In , you can also save and copy a Preset to a new location. This
allows you to save any changes that you have made to the Preset.
Note that if you are saving the Preset to the same location (same preset number)
the screen will say 'SAVE TO' and if you are saving to a different location
(different preset number), the screen will display 'COPY TO'.
Preset Mode
1. While you are in
above.
2. You can select the location where you want to save the Preset by turning the [VALUE] knob.
When you do this, you will notice that the 'PRESS ENTER' segment will begin to blink.
3. Press [ENTER] to save current Preset to the destination. Pressing [<] button or [PRESET] button cancels the
operation and returns you to the Preset play mode.
PAGE 3 – NAME PRESET
Preset Mode
While you are in
you can assign specific names to different Presets so you can quickly identify
and access different controller configurations.
1. To name or rename the Preset, press the [>] button until you see 'Preset
Name' displayed on the screen.
You will notice that the first letter of the name will begin blinking.
2. Turn the [VALUE] dial to change the blinking character.
3. To move between the characters, use [<] and [>] buttons.
4. When done, press [PRESET] again. The name will be saved.
, you can change Presets with the [VALUE]
Pressing
, press [>] button until you see the 'SAVE TO' screen similar to the one shown
, you can also change the Preset name. This way
[<] button or
9
PRESET NAME PRESET NUMBER
DESTINATION
ENTER PRESET NAME IN
THIS FIELD