Getting Started; Design And Installation Considerations; Tools And Supplies Needed; Inspect Appliance And Components - Monessen Hearth Lyric Series Installation & Owner's Manual

Unvented room heater
Table of Contents

Advertisement

2

Getting Started

A. Design and Installation Considerations
Installation MUST comply with local, regional, state and
national codes and regulations. Consult insurance carrier,
local building inspector, fire officials or authorities having
jurisdiction over restrictions, installation inspection and
permits.
Before installing, determine the following:
Where burner assembly is to be installed.
Gas supply piping.
Whether optional accessories—devices such as a wall
switch or remote control—are desired.
Approved wood burning masonry fireplace or vent-free
fireplace.
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Tape measure
Gloves
Voltmeter
Manometer
Phillips screwdriver
Safety glasses
Flat blade screwdriver
Soapy water solution for gas leak testing
Electric drill and bits (1/4 in. magnetic)
External regulator (for propane/LPG only & 1/2 psi
Natural gas system
Piping which complies with local codes
Pipe sealant approved for use with propane/LPG
(Resistant to sulfur compounds)
Gloves are recommended when handling glass
media. Pieces are sharp and jagged and may
cause small cuts or splinters to hands. Always
make sure glass is cool before handling
Manual shutoff valve
Sediment trap
Tee joint
Pipe wrench
Monessen • Lyric Owner's/Installation Manual • 4616-900 Rev. H • 04/21
C. Inspect Appliance and Components
• Carefully remove the appliance and components from
the packaging.
• Report to your dealer any parts damaged in shipment.
• Read all of the instructions before starting the instal-
lation. Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
WARNING! Risk of Fire or Explosion! Damaged parts
could impair safe operation. DO NOT install damaged, in-
complete or substitute components. Keep appliance dry.
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT use this appliance if any part has been under
water. Call a qualified service technician to inspect the
appliance and to replace any part of the control system
and/or gas control which has been under water.
WARNING: This product and the
fuels used to operate this product (liquid
propane or natural gas), and the products
of combustion of such fuels, can expose
you to chemicals including benzene, which
is known to the State of California to cause
cancer and reproductive harm. For more
information go to: www.P65Warnings.
ca.gov.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents