Table of Contents
Advertisement
Note:
The system should automatically correct
the target application rate. If the system does
not correct the application rate, review
up the System (page
9.
After spraying a swath, switch the foot switch
to the
position to shut off the spray flow to
OFF
all booms.
Note:
This also shuts off the area calculations.
10.
Verify the area covered and the volume of
material sprayed.
Setting
13).
Operating Tips
Increasing the RTK Reception
Reduce the machine speed when you are approaching
an area with known RTK reception difficulty.
Using the Manual Control
To boost pressure for the hose reel and mixing
chemicals, use the manual control to boost pressure.
Improving the Application Rate
Set the agitation PWM (preset agitation value)
to approximately 69 kPa (10 psi) above the
target-spraying pressure.
Maintaining Speed
Maintain a steady speed and direction in a straight
line.
Creating a Backup File of
Boundaries
Save a backup file of all field boundaries in an
alternate location.
14
Advertisement
Table of Contents
