GUTMANN Futura 01 ML Operating Instruction page 13

the operation of moving parts. The hood
can then be placed back into operation after
remedying the cause of the disturbance by
pressing button 1. The functions of the hood
as well as the power level of the external
motor can be controlled in two different
ways:
Remote Control: (only Futura 01 ML)
The control panel consists of a radio remote
control with 6 buttons which can be
programmed with different functions.
Button 1 = ON / OFF Hood
Button 2 = EXTEND/RETRACT Hood
Button 3 = Exhaust Power
Button 4 = Exhaust Power max.
Button 5 = Cool Down Period
Extend Hood (2)
The hood extends from the counter by
pressing button (2). Press the button again,
on the hood will retract into the counter.
Press button (1) to turn on the hood. The
hood will begin running at a low level (one
LED illuminated). Exhaust Power The
exhaust power is controlled by pressing
button (3) multiple times. The individual
levels, however, must be switched to
sequentially. 4 different power levels can
be selected. The respective power level will
be displayed by the LEDs.
saturation Button pressures (~15sec.) to a
red LED goes off !
Automatic Cool Down Period
Press button 5 (the green LED will blink)
and then the automatic cool down period
will be activated automatically. The exhaust
hood will progressively switch from level 3
down to level 1 and run at that level
for approximately 15 minutes before turning off.
Clean Grease Filter Alert
The metal filter must be cleaned when the
red LED lights up (see section on cleaning
and care). The filter saturation display will
/
+ --
(1)filter
light up after a maximum of 15 hours of
operations or every 14 days (even if there is
no cooking performed).
Operation via toggle switch : Futura 02 ML
(situated on the hood body next to the plate)
Pressing the switch to the right: fan power
control. Pressing the switch to the right for
3 seconds: Hood switches off. The filter
saturation display is also reset via this
switch. For this, please press the switch to
the right until the red LED goes out.
LED Displays (9)
LED 1: Indicates operational status ON/OFF
LED 1: blinking: Indicates automatic cool
down period
LED 2: Exhaust power level 1 (low)
Button 3: Press the remote control once
LED 3: Power level 2 (medium)
Button 3: Press the remote control twice
LED 4: Power level 3 (high)
Button 3: Press the remote control three
times
LED 5: Intensive level (motor automatically
returns to level 3 after 3 minutes)
Button 3: On the remote control
LED 6: Filter Saturation Indicator
en
13