Table of Contents
Advertisement
3.
Slide paper under nozzle (see Figure 25).
Adjust wing nut under nozzle until nozzle
barely touches paper.
Paper
Wing Nut
(1 of 3)
Figure 25. Paper used to measure leveling
adjustments.
Note: There should be noticeable resistance,
but paper should not be difficult to move.
4.
Remove paper and press "Point2" icon (see
Figure 26). Repeat Step 3 for second point.
5.
Remove paper and press "Point3" icon (see
Figure 26). Repeat Step 3 for third point.
Figure 26. Leveling menu.
6.
Repeat Steps 2–5 and check that nozzle
height remains equal across all three points.
— If distance between nozzle and build plate
is equal across all three points, the level-
ing process is complete.
— If distance between nozzle and build plate
is NOT equal across all three points, repeat
leveling process until build plate is level.
Model G0922 (Mfd. Since 07/20)
Nozzle
Preparing Build Plate
Before printing, adhesive must be applied to the
build plate to ensure first layer of filament sticks
and does not warp.
Tools Needed
Glue Stick .......................................................... 1
To prepare build plate:
1.
Open (2) clips at front of build platform and
remove build plate (see Figure 27).
Figure 27. Build plate clip in open position.
2.
Use glue stick to apply thin layer of glue to
surface of build plate. Glue should be evenly
distributed without noticeable chunks or high
points.
3.
Slide build plate under rear clips of build plat-
form, then close (2) front clips (see Figure 28).
Front
Clips
Figure 28. Build plate with glue applied and in
position on build platform.
Qty
-25-
Advertisement
Table of Contents
