Table of Contents
Advertisement
Additional Safety for 3D Printers
Serious burns can occur from contact with the nozzle. Gas and ultrafine particles may be
released during operation. Avoid extended proximity to printer when printing in an enclosed
space. To reduce these risks, anyone operating this machine MUST completely heed the
hazards and warnings below.
HOT COMPONENTS. When heated, nozzle and
heated build plate can burn immediately on con-
tact. Do not touch nozzle or build plate when hot.
Allow components time to cool before performing
maintenance.
MAINTENANCE/SERVICE. Always stop printer
and wait for parts to come to a stop before making
adjustments or servicing.
PINCH HAZARD. Do not reach into machine
or touch built plate during operation. Injury may
occur if operator comes into contact with moving
parts.
Like all machinery there is potential danger
when operating this machine. Accidents are
frequently caused by lack of familiarity or
failure to pay attention. Use this machine
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, serious
personal injury may occur.
-12-
ADEQUATE VENTILATION. Filament may pro-
duce ultrafine particles or toxic gasses. Exact
health risks vary depending on filament used.
Make sure work area is adequately ventilated. PLA
filament is recommended to minimize health risks.
FIRE HAZARD. Do not leave printer unattended
for extended periods of time, and always stop
and unplug printer if printing error occurs. Ensure
smoke alarms are installed near printer and fire
extinguishers are easily accessible.
No list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Model G0922 (Mfd. Since 07/20)
Advertisement
Table of Contents
