Maintenance And Care - Flex CF 18.0/230 Original Operating Instructions

CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short-
circuit the contacts; explosion and fire hazard!
Installing/Removing AC adapter
for use with AC Power
■ Turn the control switch 4 to the OFF
position.
■ Insert the cylindrical end of the AC/DC
adapter 12 into the AC/DC socket 5.
(see figure D)
■ Connect the AC/DC adaptor plug to the AC
power source.
■ Make sure that the AC/DC adaptor 12 is
secured before beginning operation.
To Start/Stop the Fan
■ Connect the portable fan to a power cord
or to an approved battery pack.
■ Turn the control switch 4 clockwise to turn
the fan ON and to adjust the fan speed.
(see figure E)
■ To stop the fan, turn the control switch
counterclockwise to the OFF position.
Changing Fan Speed
■ For high speeds, rotate the control switch
4 clockwise.
■ For low speeds, rotate the control switch
counterclockwise.
Adjusting Fan Angle
■ To adjust the fan angle, grasp fan by the
carrying handle 1 and tilt fan head forward
or backward. (see figure F)
■ The fan can pivot forward within a range of 50°,
the fan can pivot backward within a range of
.
°
130
Hanging/Mounting the Fan
Your fan has a variety of hanging options.
Choose the option that is best suited for your
location.
NOTE: The portable fan can hang in a vertical
or horizontal position. Be careful not to hang
the fan in such a way that it prevents normal
fan operation or damages the cord.
Hanging the fan using the key
hole
■ Place the wide portion of at least two of
the key holes 9 over the heads of a screws.
(see figure G)
12
■ Slide the portable fan down until the
screws are inside the narrow portion of the
key hole and the fan is secure.
Hanging the fan using the hooks
■ Pull the hooks 6 completely out of their
slots and rotate them as needed. (see
figure H)
■ Hang the fan from a sturdy location.
NOTE: Hooks will not rotate until they are
fully extended.
Mounting the fan to rods using
the rod pockets
The fan can be mounted to secured rods,
tubes, or rebar using the two rod pockets 8
on the base of the fan. (see figure I)
NOTE: The mounting posts must have a
diameter between 12.7 and 17.78 mm. Align
the rod pockets with the rods and slide the
fan down onto the rods.
Mounting the fan to a tripod
using a tripod mounting hole
■ Place the fan on the tripod mounting
screws (15.87mm or 6.35 mm). Make sure
the mounting hole 7 on the base of the fan
seats completely onto the mounting screw.
(see figure J)
■ Turn the fan clockwise to secure it to the
tripod.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior
and motor with dry compressed air.
Spare parts and accessories
For other accessories, in particular tools and
cooling fan accessories, can be found in the
manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
CF 18.0/230