General Operation - iBell IBL RV19-26 Operator's Manual

WARNING!
papers, pull curtains, power cords, and any fragile objects. If the
Robot passes over a power cord and drags it, there is a chance an
object could be pulled off a table or shelf.
Refer specific instructions on page no. 4 and 5 before operation.
 Plug in the Charging station and place the remaining wire into the
trunking at the bottom of the dock.
Place the dock station on a hard level surface and against a wall.
(
1.5 meters in front and 1 meters on both sides of the dock
 Make sure the power switch is ON. Press any cleaning mode
buttons on the robot or remote control or mobile applications to
activate cleaning.
 When the robot is cleaning, pressing any cleaning mode button on
the robot or remote control may stop the robot from current
cleaning mode.
modes are stated on page no. 16)
 The robot automatically conducts route planning when cleaning.
It may pause temporarily to recalculate its cleaning path. This is
normal. Please be patient, the frequency and duration of the
pause is determined by room complexity.
 If its battery gets low before finishing a cleaning cycle, robot
returns to the dock to recharge. If the charging dock is
inaccessible, Robot will not be able to recharge, please place the
robot manually on the dock for charging.
Using Magnetic Strip (an optional accessory),
you can keep the Robot away from any area
or room you do not want it to clean as well as
not to enter stairs or balcony, to avoid falling,
as it can detect these strips.
It has an anti-falling sensor in-built to avoid the drop as well,
though the use of strip is recommended (to avoid any sort of
hazard). This is easily available in the market and cheap.

GENERAL OPERATION

Before using Robot, pick up objects like clothing, loose
(Detailed explanations on the different cleaning
22
)
IBL RV19-26