Table of Contents
Advertisement
REMOTE CONTROL
The IR remote uses one out of (4) available address channels
for control of the test pattern generator, allowing up to (4) to
be located in the same area while being controlled by different
remotes.
To configure this, select "IR Controller Address" within the
"Setup" section of the OSD's main menu.
Assign an address number (from 0 to 3) that matches the setting
on the remote that is to be used with the unit.
The IR remote's address can be set using the (2) DIP switches
located on the back of the remote, inside the battery cover. The
default factory setting is 0 (off, off).
q ANALYZER/PATTERN:
Press to switch between Analyzer
Mode and Pattern Mode.
w EDID:
Press repeatedly to switch between the available EDIDs for the HDMI input.
e COLOR SPACE:
Press repeatedly to switch between the available color space formats (RGB,
YCbCr 4:4:4, YCbCr 4:2:2 & YCbCr 4:2:0).
r HDCP SW.:
Press to switch between supported HDCP versions or to disable HDCP.
t FORMAT:
Press to switch between DVI and HDMI output formats.
y VGA~4K6G:
Press to directly select the output resolution.
u OUTPUT ON:
Press to enable video output.
i OUTPUT OFF:
Press to disable video output.
o T-/T+:
Press ◄ / ► to select a new output resolution timing. Within the OSD menu, press to
adjust selections.
P+/P-:
Press ▲/ ▼ to change the current test pattern. Within the OSD menu, press to move up
and down.
OK:
After selecting a pattern, press and hold for 2 seconds to switch to alternate variations of the
pattern. Within the OSD menu, press to confirm selections.
9
Advertisement
Table of Contents
