Programmed Edit Recording - Aiwa XC-35 Operating Instructions Manual

PROGRAMMED E DITRECORDING
This function lets you program tracks to be recorded from all of
the discs, in any order. The remaining time on each side of the
tape is displayed as you program the tracks.
5
3,8
Use the remote control.
1
2
3
4
5
6
4,6
5
11
Prepare for recording.
Load the disc(s) onto the disc trays.
Press the PRGM EDIT button.
"=4" appears around PRGM and EDIT in the display.
Press the numbered buttons to designate the tape
length.
Enter a length from 10 to 99 minutes.
Example: when using a 60-minute tape, press the 6 and O
buttons.
Press one of the DISC 1-5 buttons to select a disc.
If the disc number displayed on the window is the desired
disc to be programmed, skip step 5 and go to step 6 directly.
To set the program.
To program the whole disc, press the selected DISC 1-5
button again, the track numbers on the music calendar flash
for 6 seconds. Press the PRGM/CHECK button during these
6 seconds to enter the program.
7
8
9
Total number of
Time remaining of
programmed tracks side A
Repeat steps 5 and 6 to program the rest of the
tracks on side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Press the PRGM EDIT button to select side B.
Program the tracks to be recorded on side B.
After confirming the side in the display, repeat steps 5 and 6.
10
Select the CD or AUX function in the stereo
system.
11Start recording.
Press the E/l I button on the XC-35M to start play and the
button for recording on the connected stereo system.
After play of programmed tracks on the front side finishes, the
H
XC-30M pauses. Reverse the cassette tape and start play and
recording again. Play of programmed tracks on the reverse side
starts.
To stop recording in the middle of the program
Press the button on the cassette deck.
To check the order of the programmed tracks
Before recording, press the PRGM EDIT button to select side A
or B, and press the PRGM/CHECK button repeatedly. The tracks
in the program are shown from the first track.
To delete a programmed track
Before recording, press the PRGM EDIT button to select side A
or B, and press the PRGM/CHECK button repeatedly to display
the track to be deleted, and then press the DELETE button on the
main unit.
To change the program of each side
Press the PRGM EDIT button to select side A or B, and press
the button to clear the program of the selected side. Then
program tracks again.
To clear the edit program
Before recording, press the button twice so that "-"
around EDIT disappears.
m
In programmed edit recording, only the first 30 tracks of a disc
can be edited, even if the disc contains 31 tracks or more.
ENGLiSH
8