User Safety Information; Protocols And Procedures - Quantum 6000Z Basic Operation Instructions

User Safety Information

MANDATORY! Always secure the power chair and occupant in a forward-facing
position in the vehicle.
MANDATORY! The power chair should be used as indicated in the manufacturer's
instructions. If you have any questions about the proper use of your power chair,
contact your authorized Pride/Quantum Provider.
MANDATORY! Only belt restraints that comply with the provisions of ANSI/RESNA
WC/Vol. 4, Section 19/ISO 7176-19 and that have been dynamically tested in
accordance with this standard should be installed on the power chair for use as a
restraint in a motor vehicle.
WARNING! Use only AGM or Gel-Cell batteries to reduce the risk of leakage or
explosive conditions.
WARNING! If the total power chair mass is greater than 275 lbs. (125 kg), then
transport in a motor vehicle with a gross vehicle weight greater than 8,800 lbs.
(4,000 kg) is recommended if the option exists.

Protocols and Procedures

The power chair user should transfer into the vehicle seat and use the vehicle-installed restraint system
if and whenever feasible. The power chair should then be stored and secured in the vehicle.
If it is found necessary at the user's discretion to secure a power chair to a vehicle, the vehicle must be
equipped with a Wheelchair Tie-down and Occupant Restraint System (WTORS) that has been installed
in accordance with the tie-down manufacturer's instructions, and is compliant with ANSI/RESNA WC/
Vol. 4, Section 18/ISO 10542 standards, and the power chair must have a transit securement system
conforming to the ANSI/RESNA WC/Vol. 4, Section 19/ISO 7176-19 standards. It is essential to use
a complete WTORS to secure the power chair to the vehicle and to provide the power chair occupant
with a properly designed and tested safety restraint system. A restraint system with both pelvic and
upper-torso belts must be used to protect the power chair occupant and minimize the likelihood of injury
caused by contact with the vehicle during a crash or sudden braking.
WARNING! Only power chairs marked with this symbol are rated for occupied use.
WARNING! If the total power chair mass is greater than 275 lbs. (125 kg), then it is
recommended that two additional ANSI/RESNA WC/Vol. 4, Section 18/ISO 10542
compliant rear securement straps be used to anchor the power chair during motor
vehicle transport.
5