Advertisement
CONTENTS OF KIT
Before beginning Installation verify all items are
enclosed.
1
7
10
11
13
16
1. Protection Plate, Back
2. Bottom Plate
3. Holder (Thermal Fuse)
4. Cover (Heating element)
5. Boiler Cover
6. Rear Cover
7. Thermo Disc
8. Pop Rivet
9. Drill Bit
10. Screw, #8 x 18 x 1/2"
11. Screw, #8 x 18 x 3/8"
12. Wire, Complete
13. Thermal Fuse (Wire)
14. Service Instructions
15. Wiring Diagram 3311211.000
Wiring Diagram 3311221.000
Wiring Diagram 3312755.000
16. Screw, #8 x 1-3/8"
17. Warranty Card (not shown)
2
3
4
6
5
15
Wiring Diagram
8
9
12
14
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
2 PCS
1 PCS
2 PCS
4 PCS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
2 PCS
1 PCS
3311145.000 Secondary Burner Housing Kit Service Instructions
INSTALLATION INSTRUCTIONS
This step-by-step instruction describes how to
install the Secondary Burner Housing Assembly
consisting of a protection plate, bottom plate,
boiler cover, rear cover, holder for thermal fuse,
and cover for the heating element. Furthermore,
it explains how to install the thermo disc and
how to connect the thermal fuse and wire on
units operating on LP gas and 120 VAC energy
sources. These units are called 2-Way refrigera-
tors.
Depending on how the refrigerator's ventilation
grille is mounted, this Service Kit may be in-
stalled with the burner and burner cover in place.
However, sometimes this is not possible and
may require the removal of the burner and its
cover in order to insert the bottom plate. These
instructions explain how to go about removing
and reinstalling the burner as well as necessary
related tasks.
Note: If you fi nd that this information is not ap-
plicable to you, please skip those steps includ-
ing steps describing the loosening/tightening of
the LP gas connection and performing leak de-
tection.
During disassembly, do not discard any of the
removed screws. These will be used when
reinstalling the different parts.
PROCEED TO PAGE 4
3
Advertisement
