Advertisement
Step 40
Step 40
Step 41. Place the appropriate wiring diagram,
Item (15), on the outside center of
the rear cover. If your power mod-
ule cover measures approximately
4 inches (universal power module)
use wiring diagram 3311221.000. If it
is larger than 4 inches in height use
3311211.000
module) or 3312755.000 (integrat-
ed ignition power module) based on
whether you removed the power mod-
ule cover to complete the connections.
If you did not remove the cover, it is
an integrated ignition power module
(3312755.000). This measurement in-
cludes the mounting tab. Rear cover
must be free of oil and moisture. Clean
with a suitable cleaner and wipe dry.
Step 41
Step 41
Measure Here
Step 42. Carefully remove the wire nut that was
installed on the 12 VDC Positive (+)
power supply wire in step 23 and recon-
nect it to the 12 VDC terminal block..
Step 43. Reconnect 12 VDC power supply at
source.
(non-universal power
3311145.000 Secondary Burner Housing Kit Service Instructions
Step 44. Plug the refrigerator 120 VAC power
cord into wall receptacle.
Step 45. Reinstall the refrigerator lower side
vent access door. Make sure the drain
water hose is in its right position. Be-
fore leaving, please check that the ac-
cess door is securely engaged.
Step 45
Step 45
Step 45
Step 45
Step 45
Step 45
The service kit installation is now
complete.
16
Advertisement
