Page 2
Search for “Ring” in one of these app stores, Download from Windows Store or visit: ring.com/app. Grab your Wi-Fi password. Indoor Side Outdoor Side You’ll need it later to set up your Peephole Cam. Write it down below so it’s handy when you need it:...
Page 3
Remove the indoor half. Remove the outdoor half. On the indoor side, place the flat With the indoor side removed, edge of the tool into the slots on the outdoor portion should your peephole and rotate counter- slide right out. clockwise to unscrew it.
Page 4
Check the edges of the hole. Smooth the edges. After you’ve removed your peephole, inspect both sides of the hole If the hole in your door is smooth, skip ahead. (indoors and outdoors) for sharp or jagged edges. If there are sharp or jagged edges, use the installation tool to smooth the opening.
Page 5
On the indoor side, remove and the tube through the hole until your discard the protective orange cap Peephole Cam is flush with the door. from the end of the tube. Now head inside... We’ll continue setup from this side of...
You might need the included adapter. Remove the rear cover. It’s used to support larger door view holes. Let’s find out if it’ll fit yours... Grasp the thin edge of the indoor assembly body, and pinch the cover at the indentations. Remove the adapter from the tray.
Page 7
Using either your fingers or the install tool, twist clockwise and tighten isn’t pushed out the other side. firmly to make sure your Peephole Cam doesn’t rotate freely. Once secure, check the outdoor assembly. It may shift slightly while Once again, you may have to hold the tightening, so make sure it’s level.
Page 8
(don’t put the cover back on just yet). ensuring it is inserted. Complete setup in the Ring app. In the Ring app, select Set Up a Device and follow the in-app instructions. Once setup is complete, place the cover back on your Peephole Cam.