Vega VEGATRENN 141 Operating Instructions Manual page 13

Front cover
HART communication
sockets
VEGATRENN 141 • 4 ... 20 mA/HART
The adjustment elements are located under a hinged front cover. To
open it, use a small screwdriver in conjunction with the slot on the
upper side of the front cover. To close it, push the cover at bottom and
top firmly onto the front cover until you hear the two retaining clips
snap in.
No adjustment or configuration of VEGATRENN 141 is necessary.
Via the HART communication sockets, parameter adjustment of the
connected HART sensors can be carried out without interrupting the
measuring circuit. The resistor (230 Ω) required for this purpose is
already integrated in VEGATRENN 141 (only in case of connection of
terminals 10/12). The adjustment of the connected sensor is carried
out via a Windows PC with a parameter adjustment software such as
e.g. PACTware and corresponding DTM.
6 Setup
13