Table of Contents
Advertisement
C. Configuring PA-IP VLAN Settings
Step 1.
Click on the "VLAN" tab
Step 2.
Disable or enable VLAN tagging by setting the value of "VLAN Tagging".
Step 3.
Set the VLAN tag ID by selecting an integer (1 to 4094) in "ID for all packets".
Set the Priority Code Point (PCP) value for all not SIP and RTP packets in the "PCP for all packets" input (0 is default, priorities are
Step 4.
from low to high: 0, 1, 2, 3, 4, 5, 6, 7). Set the "PCP for SIP packets" (3 is default). Set the "PCP for RTP packets" (5 is default).
D. Manually Resetting the Security Code to Enter Programming
Note: This procedure will not erase a username and password used to access the PA-IP program mode. Only the security code is set to default.
Step 1.
Power down the PA-IP by disconnecting the LAN Cable (RJ45 plug).
Step 2.
Press and hold the Reset button, then reconnect the LAN Cable (RJ45 plug).
Continue to hold the Reset button and watch the Status LED (right behind the Reset button). The Status LED will start to flash, then
Step 3.
switches to a faster rate of flash (approximately 8 seconds after power up). Release the Reset button.
Step 4.
The security code is now reset to 845464 (factory default).
Step 5.
You can now enter programming by following the steps in section A.
E. Manually Resetting All Network Parameters to Factory Default
Note: This procedure will erase a username and password that are used to access the PA-IP program mode.
Step 1. Power down the PA-IP by disconnecting the LAN Cable (RJ45 plug).
Step 2. Press and hold the Reset button, then reconnect the LAN Cable (RJ45 plug).
Continue to hold the Reset button and watch the Status LED (right behind the Reset button). The Status LED will start to flash, then
Step 3.
switches to a faster rate of flash, then goes off briefly and comes back on steady (approximately 16 seconds after power up). Release
the Reset button.
Step 4. You can now enter programming by following the steps in section A.
7
Advertisement
Table of Contents
