Table of Contents
Advertisement
7. Security Code
The security code allows the user/installer to program the PA-IP with a PC and the required 'Viking IP Programming"
software. If the security code is left as default, the PC software won't require entering a security code when connecting
to the PA-IP. It is recommended that the factory set security code be changed. The security code can be set back to
default by holding the Reset button while the PA-IP powers up. See section D on page 7 for details. It can also be
defaulted by connecting to the unit with the IP Programming Software and clicking on the "Clear Adapter Settings" button
on the "Alarm / Firmware" tab. Factory Setting: 845464
Note: The security code must be 6 digits and cannot include a
8. Access Code
The Access Code is primarily used along with the "Auto Answer Secure" Inbound Call Mode to force inbound SIP page
callers to dial the Access Code before they can make a SIP page. The Access Code also comes into play when using
the relay of the PA-IP to open a door or gate. When you call the PA-IP and the unit automatically answers the call (see
Programming section 22), you must dial the Access Code before you are allowed to operate the door strike relays, as
extra security on inbound calls. Once a tenant has entered the correct Access Code, 2 beeps are heard and the user
can now enter any "Operation Commands" (see Operation section C). The Access Code can be disabled if this basic
security is not required. Factory Setting: 123456
Note: The Access Code can be 1 - 6 digits in length and cannot include a
Security Code.
9. Multicast Page Type
Multicast Page Type needs to be selected under the Adapter Settings tab (see picture on page 11). Select Standard or
Polycom as the source of multicast paging. If Polycom is selected as the source, the Codes / Paging screen will change
to show its options (shown below). Factory Setting: Standard (shown on page 9)
or #.
Q
or # or match the numbers used for the
Q
10
Advertisement
Table of Contents
