Viking PA-IP Product Manual page 16

34. Import / Export
The Import/Export feature is useful for backing up all the PA-IP's programming or for importing programming when installing multiple
units with a majority of the same programming.
35. Clear Adapter Settings
Clicking on the "Clear Speaker Settings" button in programming will reset all of the programming features back to their factory default
settings, including setting the unit's security code back to the default value (845464).
Note: This command will not change or reset your IP settings or Multicast paging settings.
36. Clear IP Settings
Clicking on the "Clear IP Settings" will reset all of the IP settings back to their factory default settings. This also clears Multicast IP
address / port settings and erases any username and password programmed in the unit to restrict access to programming.
37. Diagnostics
The Diagnostics section in the Viking IP Programming can be used to test the functionality of the relay. Note: This will not work
when relay mode is set to external or Alarm.
38. Night Ring Timed Operation
When Night Ring Timed Operation is enabled, if a SIP call is received during the programmed Start and Stop times, the PA-IP will
output loud ring on the "Line Out" and "Speaker Out" terminals. This is selectable for each day of the week. When outside of the
Night Ring timing window, the Inbound Call Mode setting will determine how SIP calls are handled. The Night Ring feature can also
be enabled by providing a contact closure to the trigger input on the PA-IP. All inbound SIP calls will cause the PA-IP to loud ring
when the trigger input is shorted. Note: For timed Night Ringing the unit must be synced with a time server. If the Night Ringing
feature is enabled in the software you will be asked to use Viking's Time Server when changes are applied. The address will be
entered by the software automatically.
39. Time Zone Settings
When using the Night Ring Timed Operation, the PA-IP must be synced with the network time. Set the Time Zone Settings to match
the settings on the network the unit is connected to for proper timed operation.
40. Line In
The Line In terminals can be connected to an audio source (PC, Radio, etc.) to provide low priority background music. If any SIP /
Multicast paging is active, the Line In audio is muted until the end of the page. This is a Mono audio connection. If a stereo audio
source is used, connect only the left channel.
16