ZILA KST-20 Vento Mounting And Operating Instructions page 10

Climate Controller KST-20 Vento | KST-20 Vento/CO2 | KST-20 Vento/RN
3: Mount the unit at a suitable place on the wall by
inserting the screws through the holes provided in
the housing and fastening the screws.
4: Remove the housing cover (2) after loosening the
4 screws.
5: Connect the power cable as well as the actuators
by passing the cables through the gland and
connecting them to the appropriate terminals. The
terminal blocks can be removed for this purpose.
Attention: For
information on the electrical
connection of the actuators,
please refer to the section
"Actuator connection".
6: When all electrical cables are correctly
connected, place the housing cover (2) back onto
the lower part of the housing (3) and fasten it by
loosening the screws.
Handbook Version: ENG_05052020_ANHU_KST20VENTO|
detailed
10