E-Port Configuration For Ebus Tcp - KBR multisys D2-ESET/MSMT-4 User Manual Technical Parameters

IOT ePort E20
4.2.

E-port Configuration for eBus TCP

For eBus TCP, the parameters must be set as shown in the figure below. The network
parameters (IP address, mask, gateway, DNS) must be adapted to local circumstances.
NOTE
- „Flow Control: Half Duplex" controls the changeover of RS-485 components.
- The local port must be set to 8000
- Click „Confirm" to apply the parameters.
V4.00 15