Operating Procedures (Cont.) - JTECH iStation Installation And Operating Instructions Manual

To Send a Pre-set Message:
This system has the option of sending 10 different preprogrammed messages to Alpha pagers. This
can be used for sending messages managers or key employees.
NOTE: All preset messages are stored in the ISTATION transmitter using the Alpha pre-set
messages menu. Example Messages:
Message 1 – Store Manager
Message 2 – Sales Coach
Message 3 - Zone
Message 4 – Greeter
1. Lift the telephone hand set and access the Tele-connect unit by dialing the extension number
on which the unit is installed. (For example Ext 103).
2. Your will hear "Please enter a 3 digit pager number", for example: 1 will be equivalent to
"001", 2 will be "002", "019" will be 19 and so on.
3. Enter the 3 digit pager number you want to page. You will hear "Enter a numeric message
followed by the # key". This tells you the pager number was accepted.
4. Enter the numeric number that correspond to the pre-set message then press the * (star) key.
You will hear "Thank You...your page will be sent". This tells you that the page is accepted.
Replace the handset.
Example: To send pre-set message #2 to pager # 51 using phone extension 103.
Enter 103, 051, 2 , * ".
Pager # 51 will vibrate and the display will show "Sales Coach"
800.321.6221
Operating
Procedures (cont.)
4