Subscribe to Our Youtube Channel
Related Manuals for JTECH SmartCall IQ
Summary of Contents for JTECH SmartCall IQ
- Page 1 IQ® Paging System I-Station with Keyboard 800.321.6221 ©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
- Page 2 User Manual IStation with Keyboard Paging System Setup Keypad Transmitter: Unwrap all transmitter components. Lock the antenna into the hole in the upper right-hand corner of the transmitter. Plug the power supply with the large tip into a standard 110 outlet and plug it into the back of the transmitter. Plug in the keyboard on the back of the transmitter.
-
Page 3: System Configuration
IStation with Keyboard Auto Renumbering JTECH's Smart charger allows you to number your pagers with just a press of a button > Pagers will be renumber in order according to the "starting number" which is shown on the charger’s display. The location of the pager will coincide with it's number. -
Page 4: System Programming
User Manual IStation with Keyboard System Programming Enter Programming Mode 1. Press the “SETUP” button on the base station. 2. Enter the password “1379” followed by the “ENTER” key. 3. If the password is accepted, the display will show “use * to scroll to menu options”. 4. - Page 5 User Manual IStation with Keyboard To Test the Range (Factory Default: OFF) With this feature you can determine what distance your base station will cover. To start the Range Test, follow the procedure below: 1. Remove a couple of pagers from the charging stack. 2.
-
Page 6: Pager Programming
User Manual IStation with Keyboard Pager Programming Set Pager Alert Type (Factory Default: FLASH & VIBE) Use this feature to change the way your pagers alert the guest / patron. Be sure that all pagers are returned before performing this procedure. To change the Pager Alert, follow the procedure below: 1. -
Page 7: System Operation
User Manual IStation with Keyboard System Operation Handing out the pagers: Give the guest a pager. Note their name and pager number on the sign out sheet (Included). Tell the guest the pager will signal when they are needed. The default page for this system is for the pager to flash and vibrate for 60 seconds. After the pager is finished vibrating it automatically goes back into standby mode waiting for the next page. -
Page 8: Frequently Asked Questions
What is the expected battery life? Can I buy replacements? JTECH batteries should last up to 2 years with proper use. Try charging the pager before considering replacement batteries. If after 4 hours the pager charging light still displays amber, contact JTECH to order replacement batteries. -
Page 9: Fcc Licensing Information
Control point: 1400 Northbrook Parkway, Suite 320, Suwanee, GA 30024 If you require a copy of the license, you can contact JTECH, an HME Company, or obtain one from the FCC web site (www.fcc.gov). You may, however, want to apply for your own FCC license. Whether you use JTECH, an HME Company’s, FCC license or obtain your own, you are responsible for complying with the FCC rules and requirements... -
Page 10: Radio Compliance
(Applies only to users outside of the United States) JTECH paging and radio systems operate on radio frequencies that are regulated by international treaties. In order to transmit on these frequencies, you are required to have a license issued by the licensing authority in the country of operation.
Need help?
Do you have a question about the SmartCall IQ and is the answer not in the manual?
Questions and answers