Advertisement
Tele-connect Paging System
Installation and Operating Instructions V 6 09
System Components:
• Tele-connect Transmitter
• Antenna
• Tele-connect Power Supply
• Telephone Cord
800.321.6221
©2018 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
Advertisement
Table of Contents
Related Manuals for JTECH iStation
Summary of Contents for JTECH iStation
- Page 1 Installation and Operating Instructions V 6 09 System Components: • Tele-connect Transmitter • Antenna • Tele-connect Power Supply • Telephone Cord 800.321.6221 ©2018 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
- Page 2 Installation Step 1: Have your telephone system vendor pull an Analog phone line off of your phone system and place a phone jack where you want the sending unit located. There must be an extension number attached to the phone line and jack. Step 2: Lock the antenna onto the antenna jack on the right hand corner of the receiver unit.
- Page 3 Operating Procedures Paging a Vibe Only Pager (No Display) To access the Tele-connect system via telephone, follow these procedures: 1. Lift the telephone hand set and access the Tele-connect unit by dialing the extension number on which the unit is installed. (For example Ext 103). 2.
- Page 4 This system has the option of sending 10 different preprogrammed messages to Alpha pagers. This can be used for sending messages managers or key employees. NOTE: All preset messages are stored in the ISTATION transmitter using the Alpha pre-set messages menu. Example Messages: Message 1 –...
- Page 5 Control point: 1400 Northbrook Parkway, Suite 320, Suwanee, GA 30024 If you require a copy of the license, you can contact JTECH an HME Company or obtain one from the FCC web site (www.fcc.gov). You may, however, want to apply for your own FCC license.
- Page 6 THESE DEVICES COMPLY WITH PARTS 90 AND 15 OF THE FCC RULES, AS APPLICABLE. OPERATION IS SUBJECT TO THE CONDITION THAT THE DEVICES DO NOT CAUSE HARMFUL INTERFERENCE. MODIFICATION OR CHANGES NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. IMPORTANT NOTE: To maintain compliance with Radio Frequency exposure guidelines, the transmitter and antenna must be at least 8 inches (20 centimeters) from any person.
Need help?
Do you have a question about the iStation and is the answer not in the manual?
Questions and answers