Operating Procedures - JTECH iStation Installation And Operating Instructions Manual

Paging a Vibe Only Pager (No Display)
To access the Tele-connect system via telephone, follow these procedures:
1. Lift the telephone hand set and access the Tele-connect unit by dialing the extension
number on which the unit is installed. (For example Ext 103).
2. You will hear "Please enter a 3 digit pager number", for example, 1 will be equivalent to
"001", 2 will be "002", "019" will be 19 and so on.
3. Enter the 3 digit pager number you want to page followed by the pound sign (#).
4. You will hear "Thank You ...your page will be sent" indicating that the pager number was
accepted and the message has been sent. Replace the handset.
Example:
To page pager # 107 using phone extension 103.
Enter 103,107, #" Pager # 107 will flash and vibrate.
To Send a Numeric Message to a Display Pager:
1. Lift the telephone hand set and access the Tele-connect unit by dialing the extension
number on which the unit is installed. (For example Ext 103).
2. You will hear "Please enter a 3 digit pager number", for example: 1 will be equivalent to
"001", 2 will be "002", "019" will be 19 and so on.
3. Enter the 3 digit pager number you want to page. You will hear "Enter a numeric message
followed by the # key". This tells you the pager number was accepted.
4. Enter the numeric message you wish to transmit followed by a # sign. You will hear "Thank
You...your page will be sent". Replace the handset.
Example:
To send message 770 555 1234 to pager # 3 using phone extension 103.
Enter "103, 003 , 7705551234, #".
Pager #3 will vibrate and the display will show 7705551234.
800.321.6221

Operating Procedures

3