Charging The Wattsun Dock And Pack - Wattsun Dock 2000 Operating Instructions Manual

LED bar Pack
The LED bar shows the status of the battery with 5 LED lights. The battery status of the Pack
is displayed for 5 seconds when the push button is pressed.
Battery level
The battery level is indicated by the number of green LED lights. If the battery
level of a Pack is lower than 5%, the LED light on the far left will light up orange.
100 - 90 %
90 - 70 %
70 - 50 %
50 - 30 %
30- 5 %
<5 %
Charging
While charging, the LED bar stays illuminated. The charging status is indicated
by the LED light blinking. When it's complete (100%) and the battery cells are fully
balanced, all LED lights light up green.
100 %
99 - 90 %
90 - 70 %
70 - 50 %
50 - 30 %
30 - 0 %
Error
In case of a system error, all LED lights blink red.
Safety break
During a safety break, all LED lights blink green. Safety break is automatically
activated in case of an overload, by requesting more than 1500 watts of power, or when
the temperature of the battery is too high.
28 - English
In the stack
The LED bar of the Pack that supplies power is always illuminated. The LED bars
on the other Packs in the stack are turned off by default. Press the touch button to display the
battery level of the individual Packs.

Charging the Wattsun Dock and Pack

1. Turn off the Wattsun Dock before you start charging. The Pack is automatically turned
off when it's not being used in a stack.
2. Connect the "Wattsun charger 360" to the mains (230 Volt).
3. Lift the cover on the rear of the product.
4. Plug the connector of the charger into the charging port (A).
5. Turn the connector to the right (B) until a "click" is heard (C). The charger is
now locked.
6. Switch the on / off button on the charger and the product will start charging.
7. The battery status of the Dock is shown on the Docks' display. The 5 Leds on the Pack
indicate the charging status of a Pack.
8. Never use any other charger but the originally supplied charger: The Wattsun
Charger 360.
A
29 - English
B C