How Does It Work; Wattsun Dock Display - Wattsun Dock 2000 Operating Instructions Manual

How does it work?

Wattsun Dock Wattsun Pack
The dock is the base of the Need more capacity?
Wattsun system. Plug in Stack the Pack(s) on top
and you are immediately of the Dock. The intelli-
supplied with power. On gent operating system
the convenient display, all takes care of the rest.
important information,such
as battery status, can be
found at a glance.
Behind the sturdy design and the ease of use, hides a unique technique. The patented
stackable battery systems makes it possible to connect different modules without using
cables.
The top module is the first to provide energy. As soon as it's empty, the next module
automatically takes over. In the meantime you can easily change the empty module,
continuously staying supplied with power. Even while in use!
Wattsun Stack
Stack up to five modules.
(1 Dock plus 4 Packs) to
expand the capacity.
Empty pack? No problem,
just change it! You'll be
ensured of power
contantly.
24 - English
Installing
• Carry the Wattsun with both hands.
• Place the Wattsun on a safe, dry, flat and stable surface.
• Place the Wattsun on the four feet.
Connecting
• Hold the power button for 4 seconds.
• Plug your electrical device in the 230V socket.
• Place the Wattsun on the four feet.
Check before use
• Check the battery level.
• View the remaining time in hours and minutes with current use.
• The display will automatically switch off after 3 minutes. Briefly press the
power button to turn it on again.
Expand capacity
• Stack a Pack on a Dock to expand the capacity.
• The Packs can be stacked both ways (left or right).
• Stack up to five modules. (1 Dock plus 4 Packs).
•
Packs can be switched while being in use.
• The top module is the first to provide energy. As soon as it's empty, the next module
automatically takes over.
Storage
• Always turn off the Dock after use.
• Hold the power button for 4 seconds to turn the Dock off.
• Make sure the Wattsun is clean and dry before storing.
Charging the battery
• Turn off the Dock before charging.
• Each Wattsun is equiped with a charger port on the backside of the module. Plug
the Wattsun charger into a power outlet (230V) and connect it to the module.
• Turn on the Wattsun charger by flipping on the on/off switch on the charger itself.
• The battery status of the Dock is shown on the Docks' display. The 5 Leds on the
Pack indicate the charging status of a Pack.
25 - English