Traceable 4351 Instructions

Key-chain thermometer

Advertisement

BATTERY REPLACEMENT

Erratic readings, a faint display, or no display
are all indications that the battery is low and
needs to be replaced. To replace the battery,
remove the battery cap, located on the top
of the unit and marked open, by turning it in
the direction of the arrow (counterclockwise).
Remove the battery and insert a new Cat. No.
1039 battery. Make certain that the positive
(+) side is facing you. Incorrectly installed
batteries may damage electronics. Replace
the Battery Cap.

ALL OPERATIONAL DIFFICULTIES

If this thermometer does not function properly
for any reason, please replace the battery
with a new high quality battery (see "Battery
Replacement" section). Low battery power
can occasionally cause any number of "ap-
parent" operational difficulties. Replacing
the battery with a new fresh battery will solve
most difficulties.
1.800.561.8187
Traceable
®
is a registered trademark of
Control Company.
©
2016
Control Company.
92-4337-00 Rev. 2 061716
www.
.com
TRACEABLE
KEY-CHAIN
THERMOMETER
INSTRUCTIONS
information@itm.com
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4351 and is the answer not in the manual?

Questions and answers

Summary of Contents for Traceable 4351

  • Page 1 (counterclockwise). Remove the battery and insert a new Cat. No. 1039 battery. Make certain that the positive TRACEABLE ® (+) side is facing you. Incorrectly installed batteries may damage electronics. Replace KEY-CHAIN the Battery Cap.
  • Page 2 SPECIFICATIONS OPERATION Range: –58 to 302°F Slide the ON/OFF switch Figure 1. (–50 to 150°C) (3, Fig. 1) to ON to turn the unit on. Resolution: ±0.1° from –20.0 to 200.0°, 1° below –20.0 Slide the °C/°F switch and above 200.0° (1, Fig.

This manual is also suitable for:

90205-10

Table of Contents