Operating The Appliance; Programme Data; Aquasensor; Drying - IKEA DISKAD Instruction Manual

en Operating the appliance
1
Operating the
appliance
P rogramme data
O p e r a t i n g t h e a p p l i a n c e
The programme data (consumption
values) can be found in the quick
reference guide. They refer to normal
conditions and the set water hardness
value : . Different influencing factors
such as water temperature or line
pressure may result in deviations.

AquaSensor *

* depending on the features of your
A q u a S e n s o r
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.
28

Drying

Warning
D r y i n g
Risk of burns from touching the blow
opening 1R!
Never touch the blow opening. The blow
opening becomes hot and, in addition,
any damage will result in a chargeable
callout by customer service.
Caution!
Please ensure that the intake opening
1J is not obstructed and do not place
any temperature-sensitive utensils in the
lower basket on the rear right side
above the blow opening 1R.
The appliance is equipped with a
container.Inside is a mineral which can
store moisture and heat energy and
release them again.
During the washing step this heat
energy is used to dry the mineral and
heat up the rinsing water.
During the drying phase moisture from
the rinsing compartment is stored in the
mineral and heat energy is released.The
heat energy released is blown out into
the rinsing compartment with dry air.
This accelerates and improves drying.
These processes therefore save a great
deal of energy.