Installation; Cabinet Requirements; Technical Data - Faber FBH 64 BK Installation Manual

Installation

EN
Installation must be carried out in compliance with
current standards and regulations.
Installation must be only carried out by specialized
and licensed personnel.
Identification plate
The identification plate is located underneath the
appliance.

Cabinet requirements

The images on page 3 represent recommended
installation. If the dimensions are different, any
modifications are the responsibility of the installer.
The cooking hob is intended to be built into the
Z Z
worktop above a kitchen cabinet of 600 mm
width or more.
If fitting in flammable material, the guidelines
Z Z
and standards for low voltage installations and
for the fire protection must be strictly observed.
For fitted units, the components (plastic
Z Z
materials and veneered wood) must be
assembled with heat-resistant adhesives (min.
100°C): Unsuitable materials and adhesives can
result in warping and detachment.
The kitchen cabinet must allow sufficient room
Z Z
for the electrical connections of the appliance.
Suspended kitchen cabinets above the appliance
must be installed at a distance that provides
enough room for comfortable working process.
The use of hard wood decorative borders around
the worktop behind the appliance is allowed, in this
case the minimum distance remains as indicated on
the installation illustrations.
The minimum distance between the built-in
appliance and rear wall is indicated at the illustration
for the installation of the built-in appliance (150mm
for the side wall, 40mm for the rear and 500mm
minimum for any cabinets above it).
As shown on page 3, the appliance bottom
thickness is 55 mm.
When installed above a drawer or cabinet the
Z Z
hob must be fitted with a horizontal plate 20 mm
away from the worktop's bottom surface. When
installed above an oven it is not necessary to
add the horizontal plate. The space between the
plate and the appliance must be empty and no
objects may be stored or kept inside it.
Incorporation of the oven under the appliance is
Z Z
permissible for ovens equipped with a cooling
fan.
Repair
If the power cable is damaged, it must be replaced
by the manufacturer or the service or else by a
person with similar qualifications, in order to avoid
any risks.
Warning!
Before attempting any repairs on the appliance,
Z Z
disconnect the power supply.

Technical data

Product identification
Type: FHSM-B2
Models: FCH 63 GR, FBH 84 BK, FCH 84 GR,
FBH 83 BK, FCH 83 GR, FBH 32 BK
Type: FHSM-B3
Models: FBH 64 BK
Refer to the data plate placed on the bottom
X Z
side of the product.
The manufacturer provides continuously product
enhancements. For this reason, the text and the
illustrations in this manual may be changed without
notice.
7