Machine Folding Procedure - Farmet FANTOM 1050 PRO Operating Manual

8.3.2 Machine Folding Procedure

Machine Folding Procedure – Transport Position
Initial position: The machine is unfolded and recessed, both ball valves outside are opened.
Conditions that must be observed prior to the commencement of folding:
• the rear section of rollers must be lifted in the maximum position
• the machine must be lifted up to zero position
1
Lift the machine on the axle, i.e. draw out the piston-rods of the axle using the yellow circuits into the
marginal position, i.e. maximum release.
Close the ball valve of the yellow circuit.
2
Fold the machine using the red circuit.
Close the ball valve of the red circuit.
The machine is ready for transport.
Warning!!! The machine must only be transported by the axle, not rollers.
32 | 59
COMMISSIONING