Table of Contents
Advertisement
6. REMOTE CONTROL
6.1. OPERATION OF THE REMOTE CONTROL
A
B
C
D
ADD THE REMOTE CONTROL
press the learning button on the controller until the indicator turns from green to red. Then release the learning
button and press the A button on the remote control, the indicator will turn from red to green alternately 3 times
meaning the learning is successful.
DELETE THE REMOTE CONTROL
press and hold the learning button, after 6 seconds, the indicator will turn from green to red and then green again.
(attention: please hold the learning button when you have to delete the remote control memory)
WIRELESS PUSH BUTTON
to add or delete the wireless push button is the same as the remote control. Please check if the DIP switch is the
same as the image shown during the setting process
A tybe
P
U
P
S
H
U
S
H
Please check the DIP switch if it's same as the image shown (during setting process)
NOTES:
Notes:
1. The receiver has been built-in.
1. Receiver has been built-in
2. EXIT ONLY FUNCTION
2. Exit only function:
connect the outside sensor/button to the terminal OPEN-B
Connect outside sensor or button to terminal "Open-B"
connect the inside sensor/button to the terminal OPEN-A
press the FULL LOCK button on the remote control
Connect to inside sensor or button to terminal "Open-A"
Press "Full lock" button on remote
3. When in the double open mode, the synchronous cable must be connected (see manual). When the power is ON
3. When double open, synchronous cable must be connect refer to manual. Power on and
ensure the settings on both controllers are the same. If the speed is diferent during the operation, please slightly
ensure the settings on both controlleres are the same. If speed is different during operation,
adjust the open/close speed, the open/close braking speed and the opening time.
please slightly adjust open / close speed, open / close barking speed and opening time.
4. When double open, remote control must learn both controller in order to control two
4. When in the double open mode, the remote control must learn both controllers in order to control the two doors
doors at the same time.
at the same time.
5. In double open mode, accessories should connect to both controller (parallel connection)
5. In the double open mode, the accessories should be connect to both controllers (parallel connection)
INSTALLATION MANUAL / MI0315.1
A:
Always open
A. ALWAYS OPEN
C: Open and close one time
C. OPEN/CLOSE ONE TIME
B:
Automatic
B. AUTOMATIC
D:
D. FULL LOCK/EXIT ONLY
Full lock
EN
www.jnf.pt
21/72
Advertisement
Table of Contents
