Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Snell Type A
Summary of Contents for Snell Type A
- Page 1 • coust1cs TypeA � · loudspeaker - � ,• j system · · instruction .· manual...
- Page 2 Isosceles triangle with the listener at the apex. of or to the sides of Ihe Type A's. This will result In most circumstances Ihe sides should be in reflections which will affect imaging and slightly longer Ilian the base (distance between detail Several feel of free space will amply re...
- Page 3 The extraordinary accuracy and transparency in your system will have an audible effect. Under of the Type A allows il to fully reveal Ihe strengths no circumstances should 'wire of gauge higher (thinner) than /Mb be used. In general, the longer and weaknesses of the associated audio equip...
- Page 4 If no sound is heard through the "monitors" less accurate than your Type A's. With speakers, all is well. If a dull tapping is heard flawed recordings it may be useful to employ an...
- Page 5 Volume controls should be set close to The speaker grilles are not user-removabla. the minimum when tone arms are cued or radio Repairs of the Type A by the owner or dealer stations are tuned, as these may produce dan may invalidate the warranty.
-
Page 6: Power Amplifier
If one is not fortunate enough to choose an amplifier without regard for cost, bi-amplification How? allows the owner of Type A’s the ability to match an amplifier to the frequency range (high or low) In figure 4 one sees that a Snell Acoustics il is most comfortable with. - Page 7 Type A 'will be out of ferent gains in a bi-amp setup would result in an phase. The speaker wiring rnusl then be changed imbalance between upper and lower sections of lo correct the phase, as will be discussed below.
- Page 8 and checking that each speaker is working in The system should now be operational dependently and that upper and lower sections I isten to a record or tape that you are familiar of both speakers are producing sound. The with, using the balance control on the pre speakers are now correctly bi-amplified.
- Page 9 ELECTRONIC CROSSOVER LEVEL ADJUSTMENTS (left charnel shown)
-
Page 10: Specifications
SPECIFICATIONS 36 Hz to 18 kHz ± t x db Frequency response on axis and up to 25 degrees off axis* 4 ohms Impedance (minimum) 80 watts RMS/channel Power requirements (minimum) • 10-inch (24.5-cm) woofer Driver complement 4-inch (10.2-crn) midrange 1-inch (2.54-cm) tweeter 275 Hz and 2500 Hz Crossover frequencies...
Need help?
Do you have a question about the Type A and is the answer not in the manual?
Questions and answers