Troubleshooting Guide - Illuco IDS-1100 Instruction Manual

IDS-1100 Dermatoscope
10
scoping damaged or infected skin. Even so, regular exhaustive disinfection is necessary and E.O.(Ethylene oxide)
Gas sterilization method is recommended for deep disinfection.
-Inside cleaning
Note
When cleaning internal part, never touch the LED & polarization filter.
Clean the magnifying lens in the middle if only it has been contaminated. Use a lens cleaning cloth or a blower to
remover the contaminations. Polarization filters are coated to protect itself against foreign particles and dusts as
the filter itself easily attracts them like a magnetic field. If you clean polarization filter with alcohol or any fluids or
wipe it even only with cleaning cloth or tissue, it will peel off the coat. So do not wipe it. If necessary, blow off the
foreign particles and dusts with a blower or air spray.
-Storage
During work, always close the protect glass and keep the device with a protect glass side up.
When storing, put IDS-1100 in the pouch and store it in a safe place.
If you store IDS-1100 for a long time and the climate should be very humid, use silica gel. In that case, do not use
leather pouch as leather generally absorbs moisture in the air and causes mold. Do not store IDS-1100 in a room
with a temperature higher than 45 C
°

Troubleshooting guide

Note
The IDS-1100 is reliable and designed for trouble-free operation. Never attempt to open or dismantle the device
for any reason other than battery replacement. The manufacturer and distributors are not liable for mechanical
troubles, property damage or personal injury caused by the use(s) unfamiliarity with the instructions of the manual.
1 No power supply
-Recharging the battery and power on again.
If the problem persists, replace the battery with a new one.
When the both tries ended up with failure, contact the ILLUCO A/S center or your local distributor and report the