Wickes PDH32DS.2 Manual page 9

4. USING THE DEPTH GAUGE (See Fig. C)
The depth gauge (8) can be used to set a constant depth
to the drill.
Rotate the locking screw on the top of the handle anti-
clockwise to loosen, insert the depth gauge (8) into the
handle.
Adjust it to the desired depth. Rotate the locking screw
clockwise to tighten.
5. ON/OFF SWITCH (See Fig. D)
Depress the On/Off switch (5) to start and release it to
stop your tool.
6. HAMMER DRILL FUNCTION (See Fig. E1, E2)
1. Adjust the hammer or chisel action selector (2) to
position " " . (See Fig. E1)
2. Adjust the hammer or drilling action selector (13) to
position " " .(See Fig. E2)
3. You are now set up for hammer drilling into masonry.
NOTE: Press the selector switch lock button before
adjusting the dial selector everytime.
7. DRILLING FUNCTION (See Fig. F1, F2)
1. Adjust the hammer or chisel action selector (2) to
position " ". (See Fig. F1)
2. Adjust the hammer and drilling action selector (13) to
position " " . (See Fig. F2)
3. You are now set up for drilling without hammer..
NOTE: Press the selector switch lock button before
adjusting the dial selector everytime.
locking screw
Fig. C
Fig. D
lock button
Fig. E1
lock button
Fig. F1
9
Fig. E2
Fig. F2