Wickes PDH32DS.2 Manual page 10

8. CHISEL FUNCTION (See Fig. G1, G2)
1. Adjust the hammer and chisel action selector (2) to
position " " .(See Fig. G1)
2. Adjust the hammer and drilling action selector (13) to
position " " .(See Fig. G2)
3. You are now set to chisel without rotation..
NOTE: Press the selector switch lock button before
adjusting the dial selector everytime.
WARNING: You must make sure that the
selector switch is positively locked in chisel
mode position. If not, it could cause a hazard.
9. DUST COVER (See Fig. H)
Before drilling, fit the dust cover (12) over the drill bit.
CAUTION: Always wear eye protection with this
tool.
10. LUBRICATION (See Fig. I)
The gearbox is lubricated with grease. Refilling is required
when the hammer efficiency is low. Open the cover using
the spanner (11) provided and add general purpose lithium
based grease.
CAUTION: Keep the container of grease away
from children.
11. SAFETY CLUTCH PROTECTION
This tool will generate high forces when use. Always hold the tool with both hands and adopt a secure posture.
If the drill bit or chisel becomes jammed in the workpiece, the clutch will activate stopping the tool spindle. This is normal.
Switch the machine off, loosen and remove the drill bit or chisel from the work piece.
CAUTION: Switching the machine on with the drill bit or chisel jammed in the work piece will generate high reaction
torque and can result in injury.
lock button
Fig. G1
Fig. H
Fig. I
10
Fig.G2