Operating Instructions - Wickes PDH32DS.2 Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for hammer drilling in concrete, brick and stone as well as for light chiseling work. It is also
suitable for drilling without impact in wood, metal, ceramic and plastic.
1. INSERTING AND REMOVING DRILL BIT/ CHISEL (See Fig. A1,A2)
INSERTING
Clean the bit shank and apply grease before installing
the bit. Hold the rotary grip, pull back the locking sleeve
(1) and insert the bits into the chuck. Turn the SDS tool
and push it in until resistance is felt, and shaft is inserted
completely into the chuck. Once you are satisfied it has
seated, release the black locking sleeve. The SDS tool
should be locked in position.
After installing always make sure that the tool is securely
held in the chuck by trying to pull it out.
If the SDS tool is not correctly located, repeat the
installation operation
REMOVING
To remove the bit, pull back the locking sleeve (1), hold
and pull the bit out.
2. Clamping the Auxiliary Handle (See Fig. B)
Rotate the handgrip counter-clockwise to loosen the
auxiliary handle.
Slide the auxiliary handle (7) onto the drill and rotate
to the desired working position. Rotate the handgrip
clockwise to clamp the auxiliary handle. Always use
the auxiliary handle in operation.
CAUTION: Always check and rotate the handle
tightly before using to avoid any accident.
3. ANTI-VIBRATION HANDLE
The Anti-vibration handle reduces the vibration, making operation more comfortable and secure.
2
Fig. A1
2
Fig. A2
Fig. B
8
1
chuck
1
chuck