CONTENTS GENERAL POWER TOOL SAFETY WARNINGS COMPONENT LIST ACCESSORIES SYMBOLS TECHNICAL DATA NOISE INFORMATION OPERATING INSTRUCTIONS WORKING HINTS FOR YOUR ROTARY HAMMER DRILL MAINTENANCE TROUBLESHOOTING ENVIRONMENTAL PROTECTION PLUG REPLACEMENT (ONLY FOR REWIRABLE PLUG OF UK & IRELAND) DECLARATION OF CONFORMITY...
GENERAL POWER TOOL SAFETY WARNINGS injury. WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and b) Use personal protective equipment. Always wear eye instructions may result in electric shock, fire and/or serious protection. Protective equipment such as dust mask, non- injury.
Page 4
accordance with these instructions, taking into account 5. SERVICE the working conditions and the work to be performed. a) Have your power tool serviced by a qualified repair Use of the power tool for operations different from those person using only identical replacement parts. This will intended could result in a hazardous situation.
ACCESSORIES Auxiliary handle Depth gauge Dust cover Spanner SDS drill bits (8/10/12 x 150mm) SDS chisels (flat & pointed 250mm) We recommend that you purchase your accessories from the same store that sold you the tool. Use good quality accessories marked with a well-known brand name. Choose the type according to the work you intend to undertake. Refer to the accessory packaging for further details.
NOISE INFORMATION A weighted sound pressure : 96.4dB(A) A weighted sound power : 107.4dB(A) & K 3.0dB(A) Wear ear protection when sound pressure is over: 80dB(A) VIBRATION INFORMATION Vibration total values (triax vector sum) determined according to EN60745: Hammer drilling into concrete Hammer drill into concrete a = 19.372m/s h,HD...
OPERATING INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. Intended Use The machine is intended for hammer drilling in concrete, brick and stone as well as for light chiseling work. It is also suitable for drilling without impact in wood, metal, ceramic and plastic. 1.
Page 9
locking screw 4. USING THE DEPTH GAUGE (See Fig. C) The depth gauge (8) can be used to set a constant depth to the drill. Rotate the locking screw on the top of the handle anti- clockwise to loosen, insert the depth gauge (8) into the handle.
Page 10
8. CHISEL FUNCTION (See Fig. G1, G2) 1. Adjust the hammer and chisel action selector (2) to position “ “ .(See Fig. G1) 2. Adjust the hammer and drilling action selector (13) to position “ “ .(See Fig. G2) 3. You are now set to chisel without rotation.. NOTE: Press the selector switch lock button before adjusting the dial selector everytime.
Page 11
12. VARIABLE SPEED CONTROL (See Fig. J) The speed increases as you adjust the thumb-wheel (6) towards the higher number and decreases on the lower number. Avoid prolonged use at very low speed as this may cause damage. Fig. J...
WORKING HINTS FOR YOUR ROTARY HAMMER DRILL 1. Reduce the pressure on the drill bit when it is about to break through. This will prevent the drill from jamming. 2. When drilling a large hole, first drill a pilot hole using a smaller drill bit. 3.
PLUG REPLACEMENT (ONLY FOR REWIRABLE PLUG OF UK & IRELAND) If you need to replace the fitted plug then follow the instructions below. IMPORTANT The wires in the mains lead are colored in accordance with the following code: Blue = Neutral Brown = Live As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings identifying the terminals in your plug, proceed as follows.
DECLARATION OF CONFORMITY Wickes Building Supplies Limited Declare that this product: HAMMER DRILL Description and SKU code: 223724 Complies with the following Directives and Regulations: 2006/42/EC, Machinery Directive 2014/30/EU, Electromagnetic Compatibility Directive 2011/65/EU & (EU)2015/863, Restriction of Hazardous Substances Directive...