Using Pro Iii Multiple Card Reader; Specifications - Atech Flash Technology PRO III User Manual

Using PRO III
Once PRO III reader is setup successfully, you shall have 4
Removable Disk icons created in My Computer. Each of the
icons allows you to access the flash media card in the card
slot it represents.
Compact Flash
or
Memory Stick Microdrive
1394 MS CF/MD
IEEE 1394
Device
LED
SD/MMC SM
Smartmedia Card
Secure Digital
or
Multimedia Card
Using PRO III Multiple Card Reader is very similar to using a
floppy drive. Simply insert your flash media card into the slot
and click on the appropriate Removable Disk icon in My
Computer, it will allow you to access your flash media card
like a disk.
Caution !!!!!
When removing your flash media card from PRO III Card
Reader, please make sure that your file transferring process
is fully completed before pulling your flash media card out.
Failing to do so may result in card damage.
Never format your flash media cards in PRO III. Always
format your flash media card in the electronic device it is
used. Once your flash media card is formatted in PRO III
reader, it can never be used in other electronic devices.

Specifications

13
Dimension (W x H x D):
Power Requirement:
Supported media format: Compact Flash™ (Type I & II),
PRO III
Transfer rate :
Actual speed may vary, depending on the maximum performance of the
flash media card.
Supported O/S :
IEEE 1394 (FireWire) Port: (Mini) 4 Pin port, located on
14
4.02 inch x 1 inch x 4.92 inch
102 mm x 25 mm x 125 mm
5V DC ± 5% (USB Bus powered)
IBM MicroDrive™ ,
Smart Media™ (3.3V),
MultiMedia™,
Secure Digital™,
Memory Stick™
Up to 12 Mb/sec (via USB 1.1)
Windows 98
Windows 98 SE
Windows 2000
Windows ME (No driver required)
Windows XP (No driver required)
Mac OS 8.6 or later
product bezel