Optical Multi Cable Assembly (F) - Sony HDFX200 Maintenance Manual

2-11.

Optical Multi Cable Assembly (F)

Preparation
1. Remove the front panel assembly. (Refer to
2. Remove the top cover. (Refer to
3. Remove the TRIAX assembly. (Refer to
4. Remove the DM-151 board. (Refer to
5. Remove the DRX-13 board assembly. (Refer to
Procedure
1. Peel the tape.
Note
When installing the optical cables and the harnesses, arrange it as shown in the figure and then fix by the tape.
2. Disconnect the two optical cables from the optical modules connecting the connector (CN701) on the DTX-13
board.
3. Remove the rivet.
4. Open the portion B of the DTX insulation sheet in the arrow C direction and then disconnect the two harnesses
from the connectors (CN600, CN602) on the DTX-13 board.
5. Disconnect the harness from the connector (CN603) on the DTX-13 board.
HDFX200
"2-3. Front Panel
"2-4. Top Cover")
"2-6. TRIAX Assembly")
"2-7. DM-151 Board")
"2-8. DRX-13 Board/AT-189C
Tape
Harnesses Optical cables
Assembly")
Board")
Optical multi cable assembly (F)
2-19