Table of Contents
Advertisement
PCAN-Router DR – User Manual
2.
Restart the device by shortly disconnecting the power
supply or by pressing the Reset button into the hole with
the tip of small screwdriver or a paper clip.
The change of the rotary switch is now active.
The activated bootloader is indicated as follows:
LED
Status
CAN 1
CAN 2
3.
Continue with the chapter 5.3
5.3
Firmware Transfer
The firmware is uploaded via a CAN bus using the Windows
program PEAK-Flash.
Note: The firmware transfer is only possible with the CAN 1
connector. This must be connected to the PC alone.
Do the following to transfer a new firmware with PEAK-Flash:
1.
Connect the CAN interface of your computer to the CAN 1
connector on the PCAN-Router DR. Make sure that the CAN
cabling is terminated correctly (2 x 120 ).
2.
Download the software PEAK-Flash, which is included in the
development package:
www.peak-system.com/quick/DLP-DevPack
3.
Open the zip file and extract it to your local storage medium.
4.
Run the PEAK-Flash.exe.
The program opens.
Status
off
orange
blinking
orange
on
Firmware Transfer
19
.
Advertisement
Table of Contents
