Ulthera DeepSEE DS 4 - 4.5 Instructions For Use Manual page 62

H
I
J
K
L
M
62
Page
Code H
Transducer motion not detected
Please remov e and reinsert the
transducer.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code I
Communication halted
Please restart the system.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code J
Handpiece communication
halted
Please restart the system.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code K
Software halted
Please restart the system.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code L
Transducer out of lines
Please replace transducer and
continue.
See User's Manual for further
information.
Code M
Handpiece motion halted
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Transducer motion was not detected.
Ensure that the transducer is properly
mounted in the handpiece. Please be
sure to always hit Scan N before
remov ing transducer. Remov e and
reinsert the transducer.
Communication halted due to an
ev ent detected in the control unit.
Communication halted due to an
ev ent detected in the control unit.
Software was halted due to an ev ent
detected in the control unit.
The Transducer's remaining line count is
zero. Remov e and replace the
Transducer.
Inspect handpiece. Ensure that the
transducer is properly mounted and
latched in the handpiece.
Ulthera, Inc