System Messages - Ulthera DeepSEE DS 4 - 4.5 Instructions For Use Manual

8. System Messages

The Ulthera System is designed with internal checks to ensure that all aspects
of the device are functioning appropriately. In the event that an information
message presents itself during use, please follow the instructions on the screen
or refer to the information listed below.
These messages are classified as INFORMATION SIGNALS per IEC 60601-1-8.
INFO
MESSAGE DISPLAYED
CODE
B
C
E
G
Ulthera, Inc.
Code B
Internal handpiece temperature
is too high
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code C
Hardware halted
Please restart the system.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code E
Communication halted
Please restart the system.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
Code G
Hardware halted
Please restart the system.
If the problem persists please
see the User's Manual for further
information or contact Ulthera
Support.
DESCRIPTION
The internal handpiece temperature is
abov e its limit. Allow the handpiece to
cool down.
Hardware was halted due to an ev ent
detected in the control unit.
Communication was halted due to an
initialization ev ent detected in the
control unit.
Hardware was halted due to an ev ent
detected in the control unit.
61
Page