Related Manuals for CDI Meters 5250
Summary of Contents for CDI Meters 5250
- Page 1 CDI 5250 Hot-Tap Flowmeter Installation and Operating Instructions cdimeters CDI Meters, Inc. support@cdimeters.com 866-885-2462 www.cdimeters.com...
- Page 2 Limitations and Cautions CDI 5250 flowmeters are not for use in hazardous areas or on pipes containing gasses other than air or nitrogen. They must be installed in a pressurized pipe to ensure all chips are cleared.
- Page 3 Installing the Meter Installation of the CDI 5250 Hot Tap Flowmeter should be done by an experienced mechanic. As a precaution, hearing, face, and hand protection should be worn at all times. If done properly, the sound of the drill will be the loudest part of the installation.
- Page 4 When this happens, rotate the handle 90° to its closed position. It is now safe to completely remove the drill bit. At this stage a slight hiss may be present through the drill guide. © 2019 CDI Meters, Inc. 10.19...
- Page 5 To complete the installation, there are two safety screws that will need to be placed in the side of the top bracket next to each latch. Screw both in until they bottom out. © 2019 CDI Meters, Inc. 10.19...
- Page 6 The 4 - 20 milliamp output is optically isolated within the meter and it is provided with a factory-installed jumper which allows it to source a milliamp signal powered from the meter. The resistance of the loop connected to the output should not exceed 600 Ohms. © 2019 CDI Meters, Inc. 10.19...
- Page 7 Serial Communication display board. The two threaded openings in the meter enclosure permit the signal to be wired from meter to meter without external splices. Please refer to the data sheet for the Serial Communication options. © 2019 CDI Meters, Inc. 10.19...
- Page 8 Warranty CDI warrants solely to the buyer that the Model 5250 Flowmeter shall be free from defects in materials and workmanship, when given normal, proper and intended usage, for three years from the date of purchase.