EZ Way Classic Stand Safety & Maintenance Checklist

EZ Way, Inc.
Classic Stand
The Classic Stand® requires a minimum of servicing to keep it in good working order. Nevertheless, it is important
that certain basic checks be periodically made by maintenance staff to ensure on-going safety throughout the life of the
device.
The manufacturer suggests that the following components and operating points be scheduled for inspection at intervals
not greater than six months. Any detected deficiency must be rectified before the stand is put back into service.
☐
1
1. Check all bolts to ensure they are tight. Remove covers as necessary for inspection.
BASE
☐
2
2. Check arm to mast pivot bolt by removing plastic cap to ensure nut is tight
and cotter pin is in place. If plastic cap is missing order replacement.
☐
3
3. Foot platform assembly pins need to checked to ensure
they have not pushed in and still engage into base.
☐
4
4. Inspect shin pad for tears or rips.
☐
5
4. Safety tabs need to be checked to make sure they are installed correctly,
not missing or torn.
PO Box 89, 710 E. Main. Clarinda, IA 51632 I 1-800-627-8940 I sales@ezlifts.com
Safety & Maintenance Checklist
®
PIVOT REAR WHEEL FRONT WHEEL
PIN ON FOOT
PLATFORM
ARM TO MAST