Advertisement
ASSEMBLY AND OPERATION
Remember that to assemble the acquired FX head, you must previously remove the Sky
dancer head supplied from the turbine by loosening and removing the screws
Attach then snow FX head to the turbine using the screws supplied, and lining up the 4 holes.
Place the machine in the intended place, either on a fl at and stable surface or on a tripod
or even better on the fl ightcase we propose, by inserting the tube piece included with the
fl ightcase into the accommodation for tripod. In case of use of a tripod, make sure that it can
hold at least 50 kgs. Adjust the inclination of the machine (advisable about 45°) and tighten
the locking knobs. Using a tripod or the fl ightcase tripod, allows you to rotate the machine,
covering thus a larger area.
The snow FX head includes an adjustable pump for snow fl uid and a platform support for the
pump which is integrated into the turbine base through some slots.
1-
Power supply: connect the plug of the machine to a socket. Now you can turn on the
manual ON/OFF switch and the machine will begin to blow
2-
Snow fl uid: connect the pump to a socket, and the snow fl uid connection (fast couplers)
to the snow FX head. Insert the tube with fi lter inside the carafe of snow fl uid. Turn on the
pump, and will begin to absorb the snow fl uid until it produces the snow fl akes. You can then
adjust the power of the pump according to the amount of snow that you want to produce. (see
manual of the pump for further reference).
PARTS
1. Snow diff users
2. Handles
3. Switch ON/OFF
4. Snow fl uid connection
5. Locking knobs
6. Pump
7. Accommodation for tripod
8. Plug
9. Filter
14
INSTRUCTION MANUAL
Advertisement
