Advertisement
1-
Attach then confetti blower head to the turbine using the screws supplied, and lining
up the 4 holes. Place the machine in the intended place, either on a fl at and stable surface or
on a tripod or even better on the fl ightcase we propose, by inserting the tube piece included
with the fl ightcase into the accommodation for tripod. In case of use of a tripod, make sure
that it can hold at least 50 kgs. Adjust the inclination of the machine (advisable about 45°)
and tighten the locking knobs. Using a tripod or the fl ightcase tripod, allows you to rotate the
machine, covering thus a larger area.
2-
Power supply: connect the plug of the machine to a socket. Now you can turn on the
manual ON/OFF switch and the machine will begin to suck and blow
3-
Confetti: You can feed the machine through the absorption tube or also using the
fl exible hose supplied. Whenever you will use shaped confetti it is recommended to feed the
machine through the absorption tube (that is, without using the fl exible hose) and thus avoid
clogging the hose.
When using small confetti or artifi cial snow, you can put it in a box and suck it with the fl exible
hose supplied and thus better control the amount of confetti to blow. If the fl exible hose gets
stucked/clogged it is because you have fed the confetti too fast. In that case, disconnect the
hose and remove the confetti clogged.
18
INSTRUCTION MANUAL
Advertisement
